How do I assemble my flat foundation?

Pre-Assembly Instructions 

1. Remove the side and end pieces from the box. 
2. Unwrap the rubber bands at the joint locations. 
3. Remove the Fast Loc Pins from the Fast Loc Blocks. 
4. Lay all components flat and separately on the floor. 

Assembly Steps 

Step 1: Position a Fast Loc Block in each of the four corners. 

Step 2: Insert a Fast Loc Pin into each Fast Loc Block, pressing firmly to ensure proper alignment. 

Important: When removing Fast Loc Pins, always pull from the top. Do not push from the bottom, as the pins may eject forcefully. 

Step 3: Align each end of the Center Rail with the corresponding Tapered Slide Connector. Firmly press down until secure, ensuring the "Up Arrow" is facing upward. 

Step 4: Begin at the head or footboard and position one end of each Support Slat Pack. Ensure the male Velcro faces downward to connect with the female Velcro on the side rails. Unroll the Slat Packs toward the center until fully extended.